This article covers the Adyen setup for Super Wrapper application.
Steps
- Open POS Application from start page and open Settings by pressing on the cog in upper-right corner
- Press payment configuration
- Press setup payment gateways
- Select “Adyen” as current integration
- Configure “API Key” field according to your Adyen API key
- Configure “Terminal ID” field according to your Terminal ID
- Configure “Terminal IP Address” field according to your Terminal IP(note: this is optional - needed for Local connection)
- Configure “Terminal Key Identifier” field according to your Terminal Key identifier
- Configure “Terminal Key passphrase” field according to your Terminal key passphrase
- Configure “Terminal key version” field according to your Terminal key version
- Configure “Waiting time for terminal readiness” field according to your needs - default is 30 seconds.
- Configure “Connection type” field according to your desired connection type - cloud is connecting to terminal via cloud - therefore no terminal IP needed, if you use local it will connect to terminal using local network. Cloud, local means that first it will try to connect via cloud and using local as backup connection.
- Configure “Region” field according to your Region
- Configure “Check the status of terminal before operation” field - this will perform diagnostic request before each financial request - this is recommended to be turned on.
- Configure “Print receipt from POS general printer” - if you have terminal without printer or for some reason you don’t to print terminal receipts from terminal - use this setting to print Adyen receipts from general receipt printer.
- Configure “Receipt auto print” field according to your needs - if it’s enabled it will print receipts automatically, otherwise you need to press key on terminal.
- Press “Test connection” in order to see if connection works - if connection is good you will see “Connection succeeded” on screen.
- All good!